Just finished this card for a dear friend after dithering about over it for ages. I've used some sheer ribbon and jollied it up with some beads and cuttlebugging as usual. The font is Fontleroy Brown. I've used a polygon lattice that I've been working on, although I have to say it's not in the same league as Monica's!! If anyone would like the polygon lattice I will gladly put the template on.
Hi
I think I may be getting the hang of my Craft Robo at last. I made this card using a tutorial by 2 Magpies & Lucille. I made it in Inkscape and saved it as an SVG & DFX (converted to GSD - I hope)
Just going to have a go at putting a screen shot on too so here goes
Thank you to 2 Magpies & Lucille for the tutorial.
I used craft robo for cutting out the card, 65th & Birthday. Decorated by a piece of decoupage and home printed backing paper.
In the chat section Bon Bon was asking for help with a 70 card.
Hope this is what you wanted Bon Bon, you could cut the 70 out twice and stick them back to back with a little thread in between them and then sticking to the inside of the card above the oval, this way it will swing.
I've been having a play with 80 as well, did both the stencil cut card and a topper with a mat. Sorry if pink makes you sick, the colour isn't compulsory.
I needed to make a quick 40th birthday card, so came up with this. Very basic but I'm still learning It might be useful for someone for a quickie card. I've only made it as a topper because I used a pre made card blank. The flowers are cut out using a free font.
Bookmarks