This thank you topper was quickly designed in DM and converted to studio via the PDF method. The larger central mat is made using an adaptation of the letter y of the font damask ding 1. The whole topper is about 5.5 inches square and sits nicely on a 6 inch square card. I have used conqueror concept 160 gsm for the topper and concept 250 gsm for the main card. Care is needed when lifting the larger central mat from the carrier sheet. A bit of ribbon and a few beads just finish it off nicely!
I designed this (almost) square card for my cousin's birthday in December. I was pleased with the lovely warm appearance of the square mat which was achieved by drawing a square on the left hand side of my A4 cardstock and filling it with colour which I then put through the printer. In case anyone wants to use this colour the RGB values are: R 138 G 10 B 79. I have also included the insert which I did as a print and cut. Incidentally the ribbon I used is very narrow, about 3mm
DH bought me a Big Shot to use in conjunction with my Robo. One of the dies I bought to start my collection was Spellbinders Shapeabilities Frame 1. I wanted backings for it so have made these basic ones for now, I hope they might be useful to somebody else as well,
Bookmarks