Two layers..the inside being the bigger one. Cut the larger flowers on the outside layer, and the smaller on the inside layer. I you use different colours for the layers, including the inside...I printed a double sided desigh from Pink Petticoat....and of course use a pen for the wors. I did try using the pen for the big flowers before cutting them...just leaves a slight colour on the petal edge after cutting. Will try and upload a photo when son returns from a Uni field trip, over the weekend....he has the camera!
Last edited by leakycauldron; 30-03-2007 at 05:12 PM.
Adher the purple panel using foam pads.
Stick the egg cut out onto a 5p piece or a 1p then stick a round foam pad centrally onto the coin and then stick another coin to the other side of the foam pad, making a sandwich from the two coins and the one foam pad. Make sure the coins and pads are centrally placed. Place this 'sandwich' into the purple runner, so one coin is on the back behind the runner and the other coin is on the other side of the runner. This will enable the egg to spin as you tilt the card from side to side.
You will need to message me with your email address,if you would like a copy of the gsd file 'Easter Spinner Print and Cut'
as being a hi res (200dpi) sheet, it is too large to upload here.
This was something i did for the febuary newbie challenge it cuts ok when blade is sharp i need to get a new one.The font i used was balloonist and the rabbit was from wm-easter1 font. free font can't remember where!!
I couldnt decided which colour card to use to cut it so i tried a new technique to me sponge and ink pap. Not sure if i like it it"s a bit blotchy
Here's one I did late last night . . . may be a little late for this Easter! Probably best cut quite big as it's very fine in places! The ding was Beautiful Ornaments
Just a very simple Easter card - a cross set in a latticed oval. I cut the cross in silver mirri but it has come out black on the photo. The text was done with a black pen and then filled with a silver glitter pen. The font is Fontleroy Brown. Hope it may be of use to some.
Another 3d shelf type card this time with an Easter theme. There are 3 layers as like the boat card they just slide through the slots in the shelf so it's really easy to put together. Available in gsd and svg formats with assembly instructions included. You can find it here.
Last edited by Shirley Anne; 27-05-2012 at 07:38 AM.
Bookmarks