needed a teabag then i thought how much it looked like a cheesegrater when i stretched it so here you have them both...
they are straight IRL LOL. the holes are well cut too but for the smaller ones you do need a paperpeircer just to eject the teeny bits.
Last edited by traceyjohnson; 25-10-2005 at 02:28 PM.
I Live in Canada I got three kids, two dogs and "some" hens. 🐓 oh and three goats!!! And I make cheese now. Blessed are the cheesemakers. 🧀🐐🐐🐐🦆🦆
"Not worse is almost as good as better" Terry Pratchett speaking about altzimers, but it works for Aspergers too.
désolée, je ne parle pas bien l'anglais... mais j'arrive à comprendre vos messages !
contente que mes fichiers vous intéressent, en voici deux autres :
I have been reading post and enjoying the comments for a while. I have downloaded several files and have loved them. I am learning more about my software and am looking forward to sharing my first file. Thanks for the advice you all gave me on my last post and I hope this works!
Joyce
Another quick and simple one from me (lol they'll be quick and simple for a while). But here's a little cupcake I put together along with a sample card, I glazed the cherry with glossy accents.
Anyone for a Cappuccino? Thought someone might find a use for this. I cut it from quite thick card without any problem, but don't try to use the centre bit of the 'e' it's too small, just write it in with a matching pen. If you don't want the word cut out of the cup just ungroup and remove it. I cut the steam swirls from vellum and fixed with gel glue, and the spoon from silver mirri-paper. It was sized to fit a 150mm square card, but of course you can resize easily. Enjoy !
For those of you who've asked what the Font is for 'cafe', it is Pump Demi Bold LET. I may have got it from Dafont.com, but not too sure - can I say that here?!
The Font for the word 'Coffee' is Invite Engraved SF.
Could someone please see if they can open this file, as I'm having real problems with my new Robo software, been in touch with Graphtec and they're as baffled as I am.
They suggested doing something from scratch, so this is done in Inkscape and saved etc in the new Robomaster.
This is a template I made up following Lindse's request in CR Chat.
Gingerbread people! I haven't cut them, but they are quite simple so should cut no problems. They have been adapted a bit from a clipart file. Don't think they'd be very nice to eat though!
Ok guys. Here it is my first attempt at making a wedding cake. Before anyone kicks off about the design, saying to looks similar to others out there, this is my design, well my husband's anyway. And I am yet to see anything close to it myself.
I have done it in a way so that two different colours / shades are used. The base colour is the outline cake. The fancy bit comes when you cut the other cake, and use the icing sections only and glue them to the base. It gives a lovely effect I think. Do with it what you will; except sell it of course.
Hi, I saw a request by Jackie (Jack1mum) in Chat section and found this in my growing collection of dingsbats. It was created with the font Culinary Art from Dafont, but as its been worked it shouldn't need to be downloaded. Hope its of some use.
Bookmarks