I think she means under Plotter Options which is under Cut>Plotting Defaults>Setup. The default for end point was in a different spot for me. I now have the bottom left corner indented for both Origin and End Point. I like the blade returning to the top right corner... which, for some odd reason, corresponds to the bottom left. It's like you need to be looking at your CR from behind to make that corner in the diagrams correspond to the origin on the machine. Hmmm... maybe that's the key to understanding all of this! lol Okay, everyone, please rotate your CR's by 180 degrees! lol
Can you tell me what settings you have on this other screen please Susi as I think I may have changed these settings earlier when I was trying to cut in landscape mode?
Thanks for the screen shot I've got mine set the same on that screen but not sure about the other one.
these are the same screens but my start is bottom left and finish is bottom right - yet it starts and finishes top left!! Go figure
This is a pic of my CR set up
Susibi
Bookmarks