|
Donate with PayPal to help keep UKS online!
-
Help Please Now
Hi i just made my machine scream!!!
Have used a4 up to now all ok, want to cut postcard size it's cutting my mat !!!! have designed within area but do i need to set this to a different size??
worried
-
Please take my credit card away!!!!!!
Might have just been a glitch. It should be fine as it cuts where the image is on screen.
Make sure that you have unchecked the trace box in the cutting window .
LORRAINE
I'm not a complete idiot.......some pieces are missing!
-
Did you change the document settings... if the one you want isnt there you can set up a user defined one
-
I never bother changing the page size - if I'm careful with where I put my design Robo isn't going to know what size paper I have on my carrier sheet - he's just going to cut the shape. I use landscape mode and place my design in the bottom left hand corner that way I know that my piece of card which has to be slightly bigger than my design has to go on the carrier sheet in the top left hand corner as I feed it into the machine. I make sure trackenhancing is turned off and Robo just does his thing and cuts the shape.
Susibi
-
Please take my credit card away!!!!!!
When I said trace, I meant the tracking. Doh!!!!!
LORRAINE
I'm not a complete idiot.......some pieces are missing!
-
Dedicated Scrapper
I use landscape mode and place my design in the bottom left hand corner that way I know that my piece of card which has to be slightly bigger than my design has to go on the carrier sheet in the top left hand corner as I feed it into the machine.
I also cut landscape but my design is in the top left hand corner of the screen and cuts in the top left hand corner of the carrier sheet. I never have a problem cutting scraps.
-
Owner of Janome MC9900 & Brother ScanNCut
i posted about this yesterday to a reply about smaller paper size. (off cuts think it was called)
i work in landscape place my image bottom left on screen just within the thin black line thats within the red cutting line.
i lay my c/s on my desk in ladscape and place my paper/card again bottom left then i load into the robo and it cuts fine are you sure your paper was bigger than your image?
if you draw a bow around your image the width and height will show on the bottom of your screen you can then measure your paper and make sure its bigger
-
Well finally sorted it god scary!! kept doing it zooming the paper through i had set it all but had to set custom paper size? does that makes sense?
-
To stop it going backwards and forwards go into your control panel ( where the pix of your blade caps are) and untick the track enhancing button.
Susibi
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Bookmarks