Hi all, I am new to this forum. I have been using my Craft Robo for a couple years until around December last year. I packed it away in a working condition but when I took it out to use on my small project, it is exhibiting a strange problem that I have not seen before. I am trying to cut vinyl using Corel Draw which I have been using all the time when I was using it.
Here's the problem: When I send my work to be cut the message to say Rob cutter is ready to cut is shown, which is perfect. I would click OK to accept the job to be cut. The Robo cutter will then move the Vinyl back and forth as it should to identify the cutting area. After this process the cutting system just stops and would not start to cut. I have tried this process with other files that I have previously cut with this file and still not cutting.
I have tried all sorts techniques but I have failed to get it to cut. Could somebody please help me, I'm pulling my hair out.

Thanks
TB