This just an experiment and worked ok for me, but I thought It would open the door for more design and Ideas on the craft robo.
Instructions
1. I cut out the template on the robo
2. Then without taking the card off the Carrier sheet I put glue on the cut out pieces (I used quickie glue as this stays sticky)
3. I then Folded the uncut side of the card over in half pressing it down
to make sure that the pieces stuck to the uncut side....(opposite side of the card) see 1st Picture.
4. I let it dry. then opened, See the second picture that what it will look like.
5. ( To Emboss - Using my Big Shot I Sandwiched Template with an A5 card in the middle and run it through to emboss.
If You don't have a die cut machine to emboss with, you still can emboss by using a light box and an embossing tool.
I hope that I have explained it a little bit better now....
Bookmarks