pixscan

[liverbird]

Here is my reply from silhouette, hope this all helps. (the margin of error is what I was probably seeing on some of my cuts, otherwise most were more than acceptable. I tried a variety of cuts, some actual, some with offset and some with a shape around them)

I'm not sure why it would be off by a little bit. I will give you a few tips though.

Are you on a portrait? The portraits have 3 lines and you will want to put the mat and the 3rd line farthest from the roller.

It is best to do the pixscan in well-lit room to help the sensor read the registration marks and it is best to put the image as much as possible in the center of the page.

Do note that there can be a 1/16th inch margin of error.

[Neries]

When using my PixScan mat the the cutting line is always slightly off so moving the trace slightly to the right it how I work around it. My print & cut is spot on.