Reinstalling Design Master

[Minty Magic]

Hi

I have just got myself a new laptop and so need to reinstall Design Master and all the drivers etc for the Craft Robo. I remember when I bought DM when it first came out that there was a lot of info about only having it installed on one computer - this is fine as my old laptop is going to DH and he won't be using the CR

Can someone kindly remind me what I have to do to register it on new laptop - do I need to contact Graphtec etc? Oh and I need to find the install disks first - anyone know where I may have put those? Obviously somewhere safe - but where?

[BrianP]

Hi

I have just got myself a new laptop and so need to reinstall Design Master and all the drivers etc for the Craft Robo. I remember when I bought DM when it first came out that there was a lot of info about only having it installed on one computer - this is fine as my old laptop is going to DH and he won't be using the CR

Can someone kindly remind me what I have to do to register it on new laptop - do I need to contact Graphtec etc? Oh and I need to find the install disks first - anyone know where I may have put those? Obviously somewhere safe - but where?

Install everything as before and once DesignMaster is installed, start it and it will show you a new machine ID and software ID. Once you have these numbers, visit the website below and fill in the form with those two numbers and your name & address.

http://www.crafty-club.co.uk/index.php?id=61

Please be sure to double check the numbers to make sure they are correct.

Once you have sent the form, you should receive an email after a few hours which will contain your new licence file and instructions on how to install it.