|
Donate with PayPal to help keep UKS online!
-
Dedicated Scrapper
"Port in Use" error message
I've been churning out cuts for the last hour, no problem. The Robo Master crashed a couple of times and I'm not getting an error message everytime I go to cut that the USB port is in use (which it isn't). There's nothing in the print queue for the machine; I've tried restarting the computer and it's still doing the same. Any ideas?
(and I'm so sorry to keep on asking!)
love Dani xx
-
Specialising in 3D Templates
Rather than restart have you tried powering down
or trying a different usb port for robo
have you checked printer queue
xx
-
Dedicated Scrapper
What ever port you use when you first install you have to always use the same one. Perhaps you should just power everything down and rest it for 5 - 10 mins then try again or your USB port could be starting to play up.
Newbie Starter pack and cheat sheets here
Repeat after me "Google Is My Friend"
-
Really!? I'll have to keep that in mind. I guess I've been lucky so far and am using the same USB port by accident.
Take carem
Erika
-
Dedicated Scrapper
I turned it all off, restarted and it was fine....must have been "port fatigue"!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Bookmarks