has anyone cut shrink plastic on a robo

[frogzone]

Hi just wondered if anyone has cut this shrink plastic on thier robo, I was thinking of doing some print and cut and then shrinking them down to make embelishments ........

[lucylogic]

This one has been in before and I'm sure the answer was No, something about it being too thick to cut if I remember rightly, but someone can correct me if I'm wrong. Try doing a search for shrink plastic.

[emptypurse]

I have a very very thin sheet of this, wonder if that would work, it is not much thicker than photo paper

[Lucille]

Why not just try it and keep your finger of the off button.

[indium]

yeah it goes through fine. you might need to double cut but seems to be ok otherwise

[frogzone]

ok here goes !
will post piccys of results......

[emptypurse]

good luck look forward to seeing it

[Tosca]

Jeez, you've more guts than me, frogzone. I wouldn't dare try it.

Did it work?????