2 Attachment(s)
Stencil Cut - Toppers/Overlays
I just cut this with my Craft Robo and I am SO pleased with how it turned out. The picture was one I found on the internet, but I don't know where so I can't give credit.
I have attached the GSD file for anyone who would like it, but please only use it for personal use as I do not wish to infringe copyright laws, thanks :)
I also have a hummingbird in the same style and when I have vectorised, converted to GSD, and done a test cut, I will also share that.
2 Attachment(s)
Floral Frame (Stencil cut)
4 Attachment(s)
Layering Card - my contribution
How come this was "my" challenge. All I said was perhaps it could be a challenge.
Anyway here is my contribution. It cuts well but there are an awful lots of little petal bits on my carpet :lol: As this will fit an A6 card the flowers are a little small so you may have to pick out the bits.
Ruthan x
Just added square Layering Cards to fit 5" and 6" square cards.
Ruthan x
3 Attachment(s)
Three layer layering cards
Been playing with robo agin!
The pink and purple cards are the same file but treated differently. On the white centred one I cut the oval on both layers so the base card came through. On the second one I only cut the pink layer oval and in fact none of these has three layers. But the opportunity is there to cut three layers.
I then decided to simplify the file and the green and red one is the result. Again I only cut two layers and cut the oval on the topmost layer.
These are A6 cards.
Ruthan x
2 Attachment(s)
Layering Card - Ruthan's challenge
Here is another simple layering mat made in DM with aid of a square and an oblong. Again I've converted to a GSD file. I filled up my sheet with some flowers which I've left in, in case anyone would like them! I've been tatting about with this all afternoon instead of doing my ironing - you know how it is!!
3 Attachment(s)
Rurthan's challenge set 3
2 Attachment(s)
Layering contribution no.2
Made in Inkscape using the letters Q, I, S, P, X and O from Freebooter Script font. Just rotated, overlapped, welded and made into a frame.
Exported as PNG and traced in Robomaster.
Guinea pig required please, just got home and haven't hooked up in the dungeon yet. May get a chance to cut it later if no-one else does first.
ErikaP