Originally Posted by
fimcc4168
OK. Poss a craft robo 200-20 problem only, but my experience with several downloads showed varying sizes from 84-96MB. Have removed everything from desktop and trash. Reboot. Then switched off for 30 mins and same for Robo.
Upload software 2.2.0. Print calibrate page. Go to Silhouette manual, follow calibration instruction to manually use arrows to align over the first X. Did not find the Vertical/Horizontal alignment tools helpful for my machine. For others, please note, according to the manual, these are used in reverse. The horizontal slider for Vertical alignment and the vertical slider for Horizontal alignment.
I found, I needed to visually look under blade and align it to sit on the left-most point of the Horizontal line.
I have a print n Cut feature which is virtually undetectable by non-crafters:P
Silhouette team were helpful in their replies and stress this feature has been well tested on the new Cameo. (stool sitting on the fence re purchase).
Hope my experience helps others to avoid wasted time and wish everyone else success.
Fiona