Printable View
So got my machine set up and it cuts cardstock beautifully but I am now trying to cut craft foam with the auto blade.
It's not cutting through after setting it off twice. I'm not sure the auto blade is adjusting. Should I physically see it
moving from 5? Sorry, probably a really daft question!!
Susan x
Not sure what you mean Susan, what are your settings ? I would think you would need the blade to be at 10 and you should be able to see if it has moved to that number. If it’s hard to see you could pause the cut and take the blade out to check. I’m not sure you would get a good cut anyway with the autoblade as the Kraft blade is intended for cutting foam.
Ah ok that could be the problem. I thought the auto blade did foam. The little red marker doesn’t move. I have done all the troubleshooting bits and now contacted Helpline. Thank you for helping x
Have you tried to adjust the Auto Blade manually by taking it out and tapping on the cap that sits around the blade tip ? Try taking it up to 10 then back to zero and then see if it will adjust automatically to the setting you have set in the software. Also have you taken the cap off to make sure there is no debris inside the blade.
Yes I have done all that Shirley Anne! Thanks for replying. x