I am trying to install my craft robo pro 5000-40 on a windows 7..... 64 bit. I followed the instructions on graphtec link Brian added to the post when I asked how to do it. I downloaded the graphtec studio. Then the controller, then driver, not sure it installed properly, but notice said it did, then tried to update the firmware, I get to the part where it says to put the files downloaded in the "working folder" not really sure what the working folder is....... and then I followed the instructions to press the left and right arrows at the same time on the panel and text should display on the screen that says update. Now I am getting a GP- GL 1 Error..... I can not get it to display the update text on the panel. I went into the menu and then command and reset it to GP-GL and selected enter to reset it. If anyone knows anything about this I sure would appreciate any advice.
Thank you