I have been naughty

[silverst170]

Today I have been naughty and experimented a bit more than maybe I should have done

Icing is remarkably flexible so I thought I did this on my cameo with my small embossing tool, then added the blade at the last cut.. who needs a Cricut cake Machine when the Cameo can do the same...

[DJG]

That looks beautiful Tina, good enough to eat LOL

[beanpole]

That's beautiful Tina. Hope the Cameo's survived!

[Welsh_egg]

Wow ... not sure i would dare do this but is beautiful....

what icing did you use or was t the crcut sheet icing?

the only reason i havent gone down the cricut cake route is because i hear so many problems with icing consistency problems.... that is beautifully smooth..

[Lucille]

That is beautiful thanks for sharing that find.

I assume you use a carrier sheet, so anyone wanting to do this should buy a separate carrier sheet for icing.

I'm sure I read years ago you can do it with the smaller machines as well.

[silverst170]

That is beautiful thanks for sharing that find.

I assume you use a carrier sheet, so anyone wanting to do this should buy a separate carrier sheet for icing.

I'm sure I read years ago you can do it with the smaller machines as well.

I did use thick acetate sheet I brought many moons ago Lucille and I had to roll icing quite thin as I forgot to lift the rollers slightly so it rubbed a bit to say the least.

The small embossing tool did the trick nicely I could have cut out with knife really but I stuck the blade in and did the last cut with it, I am quite pleased with the result.

[cattiegracie]

looks yummy Tina

[Neries]

It looks lovely Tina, but how do you clean the blade and is it a different one from your paper/card one?

[silverst170]

It looks lovely Tina, but how do you clean the blade and is it a different one from your paper/card one?

I used the old robo blade Neries...

[tazzy]

Oooooo Interesting..... Looks beautiful ..

[Shirley Anne]

Looks great Tina - not sure I'd have been that brave !!

[Crafty-Liz]

WOW! You did a great job! Who knew you could do that with the Silhouette, LOL!

[Angel13]

WOW! You did a great job! Who knew you could do that with the Silhouette, LOL!

Hi Lizette

There is a downloadable PDF that gives you instructions on what to do and there is a YouTube video showing the Grey Craft Robo/Silhouette CC200 being used. Link is on the PDF.....

http://www.sugarveil.com/pdfs/sugarv...ic-cutters.pdf