Originally Posted by
Lucille
No it hasn't been done. In the early days I did discuss with Phil about getting the CR to do this, but he couldn't source a suitable mat that would work with the machine and lend itself to embossing, they were either too thick to thin or just plain didn't work. We saw a couple that we thought might work, but sadly they didn't. As I say that was quite a few years ago, perhaps Phil would look into again if you contacted him or he could pass it over to GAS to research, I'm sure he wouldn't mind he is very helpful and always open to suggestions.
I have had varying degrees of success with embossing using one of my Pergamano embossing tools and folded kitchen paper, as you can imagine folding kitchen paper and getting it into the machine even taped to the CS is no easy task and wasn't worth more than a couple of tries :lol: I'm not that crazy.